TPS330518DGNR，there are the best TPS330518DGNR suppiers all over the world here.These are the list and detailed contact method of TPS330518DGNR suppliers all over the world as follows.You can buy or get informations of TPS330518DGNR through email , message or tel.

suppliers of TPS330518DGNR and PDF data of TPS330518DGNR

Part Numbert

Mfg

Packt

D/C

Descriptiont

Qty

Company/Contact

TPS330518DGNR Datasheet

The internal decoupling capacitors help prevent high frequency instability however normal high frequency layout precautions are still necessary. Coupling capacitors should be physically small and be connected with short leads. It is most important that the ground connections are made with short leads to a continuous ground plane.
TPS330518DGNR Price

			Rating
Parameter	Symbol	Condition	min	typ	max	Unit
Bypass noise voltage	NBYP	BYP = HIGH, SUR = MONO = SP= LOW, "A"-wgt, FLOUT, FROUT		10	20	hlVRMS
Clsurround noise voltage (front)	NOSF	SUR = SP = HIGH, BYP = MONO = LOW, "A"-wgt, FLOUT, FROUT		20	40	[JVRMS
Qsurround noise voltage (surround)	NOSR	SUR = SP = HIGH, BYP = MONO = LOW, "A"-wgt, SLOUT, SROUT		15	30	[JVRMS
Bypass total harmonic distortion	THDB	BYP = SUR = HIGH, MONO = SP= LOW, LIN = RIN = 1VRMS, f = lkHz, FLOUT, FROUT, SLOUT, SROUT			O.l	%
Qsurround mono total harmonic distortion	THDOM	BYP = LOW, SUR = MONO = SP= HIGH, LIN = RIN = 1VRMS, f = lkHz, FLOUT, FROUT, SLOUT, SROUT			O.l	%

Note 5: RMS noise is measured with a 2-pole highpass filter at 10Hz and a 2-pole lowpass filter at l kHz. The resulting output is full wave rectified and then integrated for a fixed period, making the final reading an average as opposed to RMS. Correction factors are used to convert from average to RMS and to correct for the nonideal bandpass of the filters. Peak-to-peak noise is measured with a single highpass filter at 0.1 Hz and a 2-pole lowpass filter at 10Hz. The unit is enclosed in a still-air environment to eliminate thermocouple effects on the leads. Test time is 10 seconds. Note 6: Consult factory for units with long term stability data. Note 7: VIN = 12V, IOUT = 0, TA = 25IC, unless otherwise noted. Note 8: IOUT(MAX) (Sourcing) is 5mA for exposures greater than 100Krad (Si). Note 9: VIN = 12V, IOUT = 0, unless otherwise noted.

Suppliers Datasheet
		Exact Matc