description	IC PC CRD PWR-INT SWTCH 24HTSSOP
Technical/Catalog Information	TPS2210APWPRG4
Vendor	Texas Instruments
Category	Integrated Circuits (ICs)
RoHS Status	RoHS Compliant
Other Names	TPS2210APWPRG4 TPS2210APWPRG4
Lead Free Status	Lead Free
Packaging	Tape & Reel (TR)
Operating Temperature	-40掳C ~ 85掳C
Package / Case	24-HTSSOP
Number of Outputs	1 - Single
Type	PCMCIA/Cardbus Switch
Voltage - Input	3.3V, 5V, 12V
Current Limit	1A
Internal Switch(s)	Yes
Rds (On)	130 mOhm

TPS2210APWPRG4，there are the best TPS2210APWPRG4 suppiers all over the world here.These are the list and detailed contact method of TPS2210APWPRG4 suppliers all over the world as follows.You can buy or get informations of TPS2210APWPRG4 through email , message or tel.

suppliers of TPS2210APWPRG4 and PDF data of TPS2210APWPRG4

Part Numbert

Mfg

Packt

D/C

Descriptiont

Qty

Company/Contact

TPS2210APWPRG4 Datasheet

	Parameter		Units
ID @ VGS = 10V, TC = 25aC	Continuous Drain Current	27.4	A
ID @ VGS = 10V, TC = 1000C	Continuous Drain Current	17
IDM	Pulsed Drain Current	110
PD @TC= 25C	Max. Power Dissipation	150	W
	Linear Derating Factor	1.2	W/oC
VGS	Gate-to-Source Voltage	+20	V
EAS	Single Pulse Avalanche Energy	500	mJ
IAR	Avalanche Current	27.4	A
EAR	Repetitive Avalanche Energy	15	mJ
dv/dt	Peak Diode Recovery dv/dt	5.0	V/ns
Tj TSTG	Operating Junction Storage Temperature Range	-55 t0 150	oC
	Package Mounting Surface Temperature	300(for 5 seconds)	oC
	Weight	2.6 (Typical)	g

TPS2210APWPRG4 Price

ONE-TIME PROGRAMMABILITY (OTP) The DS1804 can be easily used as an OTP device. The user of the DS1804 can trim the desired value of the wiper position and set this position for storage as described above. Any activity through the three- terminal port can then be prevented by connecting the cs input pin to Vcc. Also, an OTP application does not adversely affect the number of times EEPROM is written, since EEPROM will only be loaded and not written during a power-up or power-down condition.
TPS2210APWPRG4 on stock

Copyright@ 2003 Microsemi 11-12-2003 REV A Page 1 Scottsdale Division 8700 E. Thomas Rd. PO Box 1390, Scottsdale, AZ 85252 USA, (480) 941-6300, Fax: (480) 947-1503

NOTES: 1. The collector of each transistor of the CA301 8 and CA301 8A is isolated from the substrate by an integral diode. The substrate (Terminal 1 0) must be connected to the most negative point in the external circuit to maintain isolation between transistors and to provide for normal transistor ac- tion. 2. OJA iS measured with the component mounted on an evaluation PC board in free air.

Suppliers Datasheet
		Exact Matc