| Part Numbert | Mfg | Packt | D/C | Descriptiont | Qty | Company/Contact | |
| TP5089P | NS | 98 | 1500 |
|
 |
||
| TP5089P | NS | . | . | . | 1500 |
|
|
| TP5089P | 89 | DIP | 1558 |
|
|||
| TP5089P | NS | . | 3000 |
|
|
TP5089P Datasheet 3. IF impedance is measured by modulating the specified test frequency with a 1000 Hz signal. RL = 22 0hms. Low and medium barrier diodes are tested at an incident power level of l mW. High barrier diodes are tested at an incident power level of 2 mW. TP5089P Price
TP5089P on stock Initial calibration is required after power-up or any other time the laser has been disabled. Disabling the AD9660 drives the hold capacitors back down to VREF. In this case, or in any case where the output current is more than 10% out of calibration, R will range from 300 I t0 550 I for the model above; the higher value should be used for calculating the worst case calibration time. Following the example above, if CHOLD were chosen as 4.5 nF, then c = RC = 550 I x 4.5 nF would be 2.5.s. For an initial calibration error <1%, the initial calibration time should be >5T = 12.4 0.
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
