STS3DNFS30L，there are the best STS3DNFS30L suppiers all over the world here.These are the list and detailed contact method of STS3DNFS30L suppliers all over the world as follows.You can buy or get informations of STS3DNFS30L through email , message or tel.

suppliers of STS3DNFS30L and PDF data of STS3DNFS30L

Part Numbert	Mfg	Packt	D/C	Descriptiont	Qty	Company/Contact
STS3DNFS30L	ST	NA	2006;06+		50000	sr weike Contact:rick Tel:86-755-83002013 Fax:86-755-83000013 Email: ddd@sr006.com

STS3DNFS30L Datasheet

Definition of Critical Performance Specifications ............. ........... 10 Absolute Maximum Ratings ......... ........... 11 Recommended Operating Conditions ....... ........... 11 DC Electrical and Power Supply Characteristics .............. ........... 12 AC Electrical Characteristics ........ ........... 13 Mechanical Specifications ............ ........... 25 Ordering Information ..... ........... 26
STS3DNFS30L Price






		¨
Tj = 150'I		J7I
Tj = 1250i Tj= 25	\|\|l	7
	\|\|\|
	\|\|\|
	\|\|l
	\|l\|
lj	\|
\|\|	\|
\|t
j\|1

STS3DNFS30L on stock

Pin	Function	Description	Interface Schematic
1	RF IN	RF input pin. This pin is NOT internally DC blocked. A DC blocking capacitor, suitable for the frequency of operation, should be used in most applications. DC coupling of the input is not allowed, because this will override the internal feedback loop and cause temperature instabil- ity.
2	GND	Ground connection. For best performance, keep traces physically short and connect immediately to ground plane.
3	RF OUT	RF output and bias pin. Biasing is accomplished with an external series resistor and choke inductor to Vcc. The resistor is selected to set the
		DC current into this pin to a desired level. The resistor value is deter-	r

	mined by the following equation: R = (VCC- VDEVICE) ICC Care should also be taken in the resistor selection to ensure that the current into the part never exceeds maximum datasheet operating cur- rent over the planned operating temperature. This means that a resistor between the supply and this pin is always required, even if a supply near 5.OV is available, to provide DC feedback to prevent thermal run- away. Because DC is present on this pin, a DC blocking capacitor, suit- able for the frequency of operation, should be used in most applications. The supply side of the bias network should also be well bypassed.		4
GND	Same as pin 2

m 8 3 ¨ 1 0 8 m - 8 S j M - g { m L n n

Suppliers Datasheet
		Exact Matc