STR-S5941，there are the best STR-S5941 suppiers all over the world here.These are the list and detailed contact method of STR-S5941 suppliers all over the world as follows.You can buy or get informations of STR-S5941 through email , message or tel.

suppliers of STR-S5941 and PDF data of STR-S5941

Part Numbert	Mfg	Packt	D/C	Descriptiont	Qty	Company/Contact
STR-S5941	SANKEN	SIP	05+	IN STOCK		GoldenSand Electronic CO.,Ltd Contact:Bruse Tel:0755-83372595 Fax:0755-83372186 Email: info@goldensand.cc
STR-S5941	SANKEN	SIP	05+	只做原装，价格优	70	thoustech electronics limited Contact:zhang Tel:86-755-82791805 Fax:86-755-82791809 Email: thoustech1@163.com

STR-S5941 Datasheet

Capacitance to an AC ground is the most likely problem. Capacitance on the LPA or LPB pins does not affect the transfer function but does affect the stability of the op amps. Capacitance on the INVA and INVB pins will affect the transfer function somewhat and will also aect the stability of the op amps. Capacitance on the SA and SB pins alters thetransfer function of thefilter. These pins are the most sensitiveto stray capacitance. Stray capacitance on these pins results in peaking of thefrequency response near the cutoff frequency. Poor layout can give 0.5dB to 1dB of excess peaking.
STR-S5941 Price

SYMBOL CBO	TEST .CONDITION VCB=-120Y, IE.O -.. .	MIN	TYP	MAX -50	UN:rT A	Collecor Cut-off Current
IEBO	YEB=-5V, IC=O ' . '			-50	pA	Emitter_Cut-off Current
V(BR)CEC	IC_-0,05A, IB=O ?	'-120			V	Collecor-Emier Breakdown Yolage
·	VCE=-5Y, IC=-1A	55		240		DC Curren Gain ' .

VCE(sat)	YCE=-jY, IC=-4A IC=-4A, IB=-0.4A	30	-1O	-2O	CoVlector Eniitter Sat\ir.a tion'Voltage	hFE(2)
VBE	YCE=-5V, IC=-4A		-1.5	-2.5	V	Base-Emitter Voltage
fT '	VCE=-10V, ICH_1A		90		MHz	Transiion 'Frequency
Cob	VCB=-10Y, IE=O, f=lMHz		150		pF	Collector Output Capacitance
						Note: hFE(l) Classification. R:55~110, 0:80~160, . Y:120~240

STR-S5941 on stock

Features 128K x 16-bit organization Fast Page Mode for a sustained data rate of 53 MHz RAS access time: 30, 35, 40, 45, 50ns Dual CAS Inputs Low Power Dissipation Read-Modify-Write, RAS-Only Refresh, CAS-Before-RAS Refresh Refresh Interval: 512 cycles/8 ms Available in 40-pin 400 mil SOJ and 40/44L-pin 400 mil TSOP-II packages Single +5V+10% Power Supply TTL Interface

The third programming option for Ultra37000 devices is to utilize the embedded controller or processor that already exists in the system. The Ultra37000 ISR software assists in this method by converting the device JEDEC maps into the ISR serial stream that contains the ISR instruction information and the addresses and data of locations to be programmed. The embedded controller then simply directs this ISR stream to the chain of Ultra37000 devices to complete the desired reconfiguring or diagnostic operations. Contact your local sales office for information on availability of this option.

Suppliers Datasheet
		Exact Matc