STP1010TAB-50 Datasheet Line and load regulation are drastically improved because there are two independent voltage loops. A voltage mode controller relies on a change in the error signal to compen- sate for a deviation in either line or load voltage. This change in the error signal causes the output voltage to change corresponding to the gain of the error amplifier, which is normally specified as line and load regulation. A current mode controller maintains fixed error signal under deviation in the line voltage, since the slope of the ramp signal changes, but still relies on a change in the error sig- nal for a deviation in load. The V2rM method of control maintains a fixed error signal for both line and load varia- tion, since the ramp signalis affected by both line and load STP1010TAB-50 Price| | | | | nn' | ¨OIl- | | INPUT Voltage Range | | 4 5 10 8 13 5 | 5 12 15 | 5.5 13 2 16 5 | VDC VDC VDC | | ISOLATION Rated Voltage Test Voltage Resistance Capacitance Leakage Current | 60 Hz, 60 Seconds Viso= 240VAC, 60Hz | 4,000 8,000 | 10 10 | 2 | VDC Vpk pF pArms | | OUTPUT Rated Power Voltage Setpoint Accuracy Ripple & Noise | Rated Load, Nominal Vin BW = DC tolOMHz BW =10Hz t0 2MHz | | 1 5 40 10 | +5 | Watts % mVp-p mVrms | | REGULA110N Line Regulation Load Regulation | High Line to Low Line See Performance Curves | | 1.5 | | %% | | GENERAL Efficiency Switching Frequency Package Weight MTTFperMIL-HDBK-217,Rev.E Ground Benign Fixed Ground NavaISheltered Airborne Uninhabited Fighter | Circuit Stress Method TA=+250C TA = +850C TA=+350C TA=+350C TA = +350C | | 75 220 12 2,000,000 90,000 540,000 300,000 55,000 | | % kHz g Hr Hr Hr Hr Hr | | TEMPERATLIRE Specification Operation Storage | | -40 -55 -55 | +25 | +85 +100 +110 | oc oC oC | | | | | | |
STP1010TAB-50 on stock| Parameter | Symbol | Values | Unit | | min | typ. | max | | | | | | |
| | | | | | j | | | | | | | j l | | | | | | | | l | | | | | | | | l | | | | Tj= | 1500c | |l | | | | | | I | l | | | | | | | | { | Tj= 250C 1 | | | | | | |
|
