| Part Numbert | Mfg | Packt | D/C | Descriptiont | Qty | Company/Contact | |
| SSS-LX5093IT-120B | LUMEX | ROHS | 08+ | LED Supplier,QQ:3293 | 50000 |
|
|
| SSS-LX5093IT-120B | LUMEX | ROHS/PB | 07+08+ |
|
SSS-LX5093IT-120B Datasheet
SSS-LX5093IT-120B Price Switching between active and standby conditions via the Chip Enable pin may produce transient voltage excur- sions. Unless accommodated by the system design, these transients may exceed data sheet limits, resulting in de- vice non-conformance. At a minimum, a 0.1 ~F high fre- quency, low inherent inductance, ceramic capacitor should be utilized for each device. This capacitor should be connected between the Vcc and Ground terminals of the device, as close to the device as possible. Additionally, to stabilize the supply voltage level on printed circuit boards with large EPROM arrays, a 4.7 ccF bulk electrolytic capacitor should be utilized, again connected between the Vcc and Ground terminals. This capacitor should be posi- tioned as close as possible to the point where the power supply is connected to the array. SSS-LX5093IT-120B on stock I SANYO Electric Co., Ltd. strives to supply high-quality high-reliability products. However, any and all semiconductor products fail with some probability. It is possible that these probabilistic failures could give rise to accidents or events that could endanger human lives, that could give rise to smoke or fire, or that could cause damage to other property. When designing equipment, adopt safety measures so that these kinds of accidents or events cannot occur. Such measures include but are not limited to protective circuits and error prevention circuits for safe design, redundant design, and structural design.
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
