SKIIP32NAB06，there are the best SKIIP32NAB06 suppiers all over the world here.These are the list and detailed contact method of SKIIP32NAB06 suppliers all over the world as follows.You can buy or get informations of SKIIP32NAB06 through email , message or tel.

suppliers of SKIIP32NAB06 and PDF data of SKIIP32NAB06

Part Numbert	Mfg	Packt	D/C	Descriptiont	Qty	Company/Contact
SKIIP32NAB06	SEMIKRON	MODULE			10	SongYuan Electronics (HK) Co.,.. Contact:Vicky Tel:86-755-83044194 Fax:86-755-83044175 Email: songyuan-chen@163.com

SKIIP32NAB06 Datasheet

Notes ' Indicates JEDEC registered data. 1. The current transfer ratio(IC/IF) is the ratio of the detector collector current to the LED input current with VCE @ 10 V 2. Pulse test: pulse width = 300ps, duty cycle < 2.0% . 3. For test circuit setup and waveforms, refer to figure 7.. 4. IF adjusted to lc = 2.0 mA and lc = 0.7 mA rms. 5. The frequency at which lc is 3dB down from the l KHz value. 6. For this test, LED pins l and 2 are common, and phototransistor pins 4,5 and 6 are common.
SKIIP32NAB06 Price

PIN	NAME	FUNCTION
1	GND	Ground
2	RESET	Active-Low Open-Drain Output. Connect to an external pull-up resistor. Can be pulled up to a voltage higher than Vcc, but less than 6V.
3	MR	Manual Reset Input. A logic low on MR asserts reset. Reset remains asserted as long as MR is low, and for the reset timeout period (tRP) after the reset conditions are terminated. Connect to Vcc if not used.
4	Vcc	Supply Voltage and Reset Threshold Monitor Input

SKIIP32NAB06 on stock

. Integrated Analog IF Front-End - FullydifferentialI/O - IF flat bandwidth from 25 MHz t0 55 MHz . 48dB minimum gain at IF frequency . Simple interface to SAW filter - 9dB input noise figure - Direct interface to A/D converter . XTAL oscillator operating t0 80MHz . More than 50dB IMD3 - Industry standard 24-lead SOIC package

				-=5V

IC	=10	Z5t
			=
	-25C		'--

Suppliers Datasheet
		Exact Matc