SKEA117，there are the best SKEA117 suppiers all over the world here.These are the list and detailed contact method of SKEA117 suppliers all over the world as follows.You can buy or get informations of SKEA117 through email , message or tel.

suppliers of SKEA117 and PDF data of SKEA117

Part Numbert

Mfg

Packt

D/C

Descriptiont

Qty

Company/Contact

SKEA117 Datasheet

Exceeding these parameters may damage the device. Maximum ambient temperature with device not switching and unloaded. These values apply to both T01089-MC500 and T01089-MC700. Typical limits are at VDD = 5.0 V and TA = 25 These are absolute values with respect to device ground and all overshoots due to system or tester noise are included This parameter is measured with device not switching and unloaded. These parameters are not 100Yo tested, but are periodically sampled.
SKEA117 Price

				\|		ff
	TEOO, r9e0.			r g
		R7
j			\|	^	W7	7i
					jf
;ONTROLLEO HECTIFIEfl TUHNEO FULLV ON 1 1			\|		CONlUC,'_,,DD

SKEA117 on stock

PARAMETER	TEST CONDITION
Output load	30 pF+1 TTL Gate
Input pulse level	0.4 V 2.4 V
Timing measurements	VDD×0.5
Reference level	VDD×0.5
tRtF	5 ns

Conversions are performed continuously as long as RESET is low and conversion is halted when RESET is high. RESET may therefore be used in a complex system to momentarily suspend conversion (for example while the address lines of an input multiplexer are changing state). In this case, RESET should be pulled high only when the EOC is LOW to avoid excessively long integrator discharge times which could result in erroneous conversion (see Applications Section).

Suppliers Datasheet
		Exact Matc