| Part Numbert | Mfg | Packt | D/C | Descriptiont | Qty | Company/Contact |
SKE4G206 Datasheet
SKE4G206 Price V- (Pins 8, 9): The V- negative supply voltage pins should be tied togetherand bypassed to GND by a O.laF capacitor in a dual-supply system. In a single-supply system, tie these pins to the ground plane. EN (Pin 10): ENABLE. When the EN input goes high or is open circuited,the LT1568 enters a shutdown state which reduces the supply current to_approximately 0.5mA (VS = 5V). The OUTA, OUTB, OUTA and OUTB pins assume high impedance states. GNDA will continue to be biased at half-supply. If an input signal is applied to a complete filter circuit while the LT1568 is in shutdown, some signal will normally flow to the output through passive components around the inactive IC. SKE4G206 on stock A high frequency ripple component may also be present on the output capacitor due to the charge transfer action of the charge pump. In this case, the output can display a voltage pulse during the output-charging phase. This pulse results from the product of the charging current and the ESR of the output capacitor. It is proportional to the input voltage, the value of the flying capacitor and the ESR of the output capacitor. Program memory can store both instructions and data, permit- ting the AD SP-2104/AD SP-2109 to fetch two operands in a single cycle, one from program memory and one from data memory. The processor can fetch an operand from on-chip program memory and the next instruction in the same cycle. |
||||||||||||||||||||||||||||||||||||
