| Part Numbert | Mfg | Packt | D/C | Descriptiont | Qty | Company/Contact | |
| SK24AR2 | TW SEMI | 07/08+ | 52295 |
|
 |
||
| SK24AR2 | TWSEMI | 7500 | 07/08+ | 52295 |
|
|
SK24AR2 Datasheet Note n: HSB STORE operation occurs only if an SRAM WRITE has been done since the last nonvolatile cycle. After the STORE (if any) completes the part will go into standby mode, inhibiting all operations until HSB rises. Note o: The six consecutive addresses must be in the order listed. W must be high during all six consecutive cycles to enable a nonvolatile cycle. Note p: 1/0 state assumes G VIL. Activation of nonvolatile cycles does not depend on state of G. SK24AR2 Price ! The products described in this document are subject to foreign exchange and foreign trade laws. O The information contained herein is presented only as a guide _for the applications of our products. No responsibility is assumed by TOSHIBA CORPORATION for any infringements of intellectual property or other rights o+-the third parties which may result from its use. No license is granted by implication or otherwise under any intellectual property or other rights of TOSHIBA CORPORATION or others. O TLe information contained herein is subject to change without notice. SK24AR2 on stock Outputs Enabled - 60 84 Notes: 1. All typical values are at V cc = 5 V, Ta = 25IC. qArODland qNoclare the changes in magnitudes of V OD and Voc , respectively, that occur when the input is changed from a high level to a low level. 2. In EIA standard RS-422A, V oc, which is the average of the two output voltages with respect to ground, is called output offset voltage, V os. 3. Only one output should be shorted at a time, and duration of the short circuit should not exceed one second. 4. Differential and common mode output voltages. AnalogicTech reserves the right to make changes to their products or specifications or to discontinue any product or service without notice, and advise customers to obtain the latest version of relevant information to verify, before placing orders, that information being relied on is current and complete. All products are sold subject to the terms and conditions of sale supplied at the time of order acknowledgement, including those pertaining to warranty, patent infringement, and limitation of liability. |
