| DATA SHEET SB820FCTSB8100FCT ISOLATION SCHOTTKY BARRIER RECTIFIERS VOLTAGE 20 t0 100 Volts CURRENT - 8 Ampere IT0-220AB Unit:inch ( mm ) |
| FEATURES LO | LO | 406(10.3) MAX i r.. | | 189(4.8)MAX |
| co | LO | 0 134(3 4) | | (o co | | 130(3.3)MAX |
| Plastic package has Underwriters Laboratory | 0 118(3.0 | 7 | |
| ridrricildUIIILy L,idSbIIIL;dLIUII U4 V -U ULiiilirig Flame Retardant Epoxy Molding Compound. Exceeds environmental standards of MIL- S-19500/228 Low power loss, high efficiency. Low forwrd voltge, high current capability High surge capacity. | i | LO rD c | c c LO | |
| For use in low voltage,high frequency inverters free wheeling , and polarlity protection applications. 071(1 8) MAX | | | | c | 1 114(2 9) o ' 098(2 5) |
| .055(1 4) MAX | | LO | 032( 8) LO MAX |
| MECHANICAL DATA .035( 9) MAX Ol | | r |
| Case: IT0-220AB full molded plastic package 1 | 1 |
| ierrriiriais: Leao soiaecaoie pec IVIIL-b I U-ZUZ, ivietrioo zuo Polarity: As marked. AC Q- MountingPosition:Any PositiveCT::] Weight: 0.08 0unces, 2.24grams. AC ~- MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Ratings at 250C ambient temperature unless otherwise specified. Single phase, half wave, 60 Hz, resistive or inductive load. For capacitive load, derate current by 20% |
| | SB820FCT | SB830FCT | SB840FCT | SB850FCT | SB860FCT | SB880FCT | SB8100FCT | UNITS |
| Maximum Recurrent Peak Reverse Voltage | 20 | 30 | 40 | 50 | 60 | 80 | 100 | V |
| Maximum RMS Voltage | 14 | 21 | 28 | 35 | 42 | 56 | 70 | v |
| Maximum DC Blocking Voltage | 20 | 30 | 40 | 50 | 60 | 80 | 1 00 | v |
| Maximum Average Forward Rectified Current at Tc=lOOoC | 8 | A |
| Peak Forward Surge Current, 8.3 ms single half sine-wave superimposed on rated load (JEDEC method) | 150 | A |
| Maximum Forward Voltage at 4.OA per element | 0 55 | 0 75 | 0 85 | V |
| Maximum DC Reverse Current at Tc=250C DC Blocking Voltage per element Tc=lOOoC | 0 5 50 | mA |
| Typical Thermal Resistance Note ROJA | 60 | 0 c/w |
| Operating and Storage Temperature Range | -50 to +125 | oc |
| NOTES: 1. Thermal Resistance Junction to Ambient . |
| | | | | | | | | | | | | | |
This bit indicates whether DS-1 support "Dl" of the power state. Only when EEPROM connects externally, this bit can be set to "1", and Dl state can support. When EEPROM does not connect externally, use ACPI mode (58-59h: ACPI Mode Register, ACPI bit) to support Dl state. The default value is "0".
