NOTE : 1. If reset command(FFh) is written at Ready state, the device goes into Busy for maximum 5us 2. To break the sequential read cycle, CE must be held high for longer time than tCEH. 3. The time to Ready depends on the value of the pull-up resistor tied R/B pin.
| | | | Limits | |
| Symbol | Parameter | Conditions | Min. | Typ. | Max | Units |
| Vsat | Output saturation voltage | Top and Bottom at Load current 0.6A. | | 1 6 | 2.2 | V |
| lleak | Output leakage current | | -100 | | +100 | c |
| VF(H) | VF of flywheel diode (Top) | If= 0.6A | | 1 7 | 2.3 | V |
| VF(L) | VF of flywheel diode (Bottom) | If= 0.6A | | 1 1 | 1.5 | V |
| tdon | Turn ON delay of output | Time until output become ON since S > Vref | | 0 5 | 2.0 | e6 |
| tdoff | Turn OFF delay of output | Time until output become OFF since S < Vref | | 2 0 | 3.5 | ccS |
| | | | | | |