| Start Up Time (nominal Vin and constant resistor load) | 30ms typ. |
| Output Power | 3W max. |
| Output Voltage Accuracy (full Load and nominal Vin) | +2% |
| Minimum Load (see Note l) | 10% of FL |
| Line Regulation (LL-HL at full load) | ±0.2% |
| DS | ±0.5% |
| Load Regulation (25% t0 100% FL) Single | ±0.2% |
| Dual | +2% |
| DS | ±0.5% |
| Cross Regulation (asymmetrical load 25%/100% FL) | +5% |
| Ripple and Noise (20MHz bandwith) 3.3V, 5V | 75mVp-p |
| others | 1 %/p-p of Vout max. |
| Temperature Coefficient | +0.02%/oC, max. |
| Transient Response (25% load step change) | 500US |
| Over Load Protection (% of full load at nominal Vin) | 180% typ |
| Short Circuit Protection | Continuous, automatic recovery |
| Efficiency | see ,,Selection Guide" table |
| Isolation Voltage In to out | 1.600VDC min. |
| Output to Output | /DS type 500VDC min. |
| Isolation Resistance | 1 09 Q ffiiri. |
| Isolation Capacitance | 300pF max. |
| Operating Frequency | 1 00kHz min. |
| Approved to Safety Standards | UL1950, EN60950 |
| Operating Temperature Range | -250C to +71 0C |
| Storage Temperature Range | -550C to +1050C |
| Vibration | 10-55Hz, 2G, 30 Min. along X, Y and Z |
| Relative Humidity | 5% t0 95% RH |
| Case Material | Non-conductive black plastic |
| Base Material | Non-conductive black plastic |
| Potting Material | Epoxy (UL94-VO) |
| Conducted Emissions EN55022 | LevelA |
| Radiated Emissions EN55022 | LevelA |
| ESD EN61000-4-2 | Perf. Criteria 2 |
| Radiated Immunity EN61000-4-3 | Peri. Criteria 2 |
| Fast Transient EN61 000-4-4 | Perf. Criteria 2 |
| Surge EN61000-4-5 | Perf. Criteria 2 |
| Conducted Immunity EN61000-4-6 | Perf. Criteria 2 |
| Weight DIP | 14g |
| SMD | 15g |
| Dimensions DIP | 31.8 x 20.3 x 10.2mm |
| SMD | 32.0 x 20.3 x 10.9mm |
| MTBF (see note 2) | 3.706 x 1 06 Hours |
| |
