RQ5RW20AA-TR，there are the best RQ5RW20AA-TR suppiers all over the world here.These are the list and detailed contact method of RQ5RW20AA-TR suppliers all over the world as follows.You can buy or get informations of RQ5RW20AA-TR through email , message or tel.

suppliers of RQ5RW20AA-TR and PDF data of RQ5RW20AA-TR

Part Numbert	Mfg	Packt	D/C	Descriptiont	Qty	Company/Contact
RQ5RW20AA-TR	RICOH	SOT	09+	Original spot and pr	50000	ZXY(sz)Electronic Co., Ltd Contact:huangli Tel:86-0755-82861952 Fax:86-0755-82543227 Email: 852215923@QQ.COM

RQ5RW20AA-TR Datasheet

D = 0.50 D = 0.33

_d - -

;D = 0.25 'D = 0.20-

]

i\iuies: riHtV fnrtnr ri

2.FeOklj=F'DMxithjC+iC I I I IIIII I I I I IIIII I I I I I

RQ5RW20AA-TR Price

Symbol	Parameter	Conditions	Min	Typ	Max	Unit
VIH	High-Ievel input voltage		2.0		vcc+ 0.3	V
VIL	Low-Ievel input voltage		-0.3		0.8	v
VOH	High-Ievel TTL output voltage	IOH = -4 mA DC, Note (8)	2.4			V
VOH	High-Ievel CMOS output voltage	IOH = -2 mA DC, Note (8)	3.84			v
VOL	Low-Ievel output voltage	IOL = 4 mA DC, Note (8)			045	v
lI	Input leakage current	vI = Vcc or GND	-10		10	LiA
loz	Tri-state output leakage current	vo = Vcc or GND	-10		10

RQ5RW20AA-TR on stock

G10.3, 2N3 The G103 and G2w signals are the 4-bit soft decision input symbols to the decoder. They are presented to the decodereither sequentially orin paralleldepending on the state of the SEQ signal. In the parallel mode (SECt = O) the symbols are clocked into the device on the rising edge of the CLK. In the sequential mode (SEQ =1) the G2w inputs are not used, both the G1 and G2 symbols are loaded via the Gk pins. The G2 symbols are then latched in on the nsing edge of CLK and the Gl symbols are latched in on the falling edge.

		VCE= 10V

	\|j	~Ta	=15 0	(

	fj?	'I
		r -	50c 15' C
Z
7

Suppliers Datasheet
		Exact Matc