RPT82BQ-883B，there are the best RPT82BQ-883B suppiers all over the world here.These are the list and detailed contact method of RPT82BQ-883B suppliers all over the world as follows.You can buy or get informations of RPT82BQ-883B through email , message or tel.

suppliers of RPT82BQ-883B and PDF data of RPT82BQ-883B

Part Numbert

Mfg

Packt

D/C

Descriptiont

Qty

Company/Contact

RPT82BQ-883B Datasheet

Parameter	Name	Test Conditions	Min	Typ.	Max	Unit
t1	Output Frequency	30-pF load 10-pF load	10 10		100 133.33	MHz MHz
	Duty Cycle[6J = t2 X/ ti	Measured at l.4V, Fout = 66.67 MHz	40.0	50.0	60.0	%
t3	Rise Time[6J	Measured between 0.8V and 2.OV			2.50	ns
t4	Fall Time[6l	Measured between 0.8V and 2.OV			2.50	ns

RPT82BQ-883B Price

PARAMETER		SYMBOL	TEST CIRCUIT	TEST CONDITIONS	MIN	TYP	MAX	UNIT
	0.5%				2483	2495	2507
Reference Voltage	1%	VREF	1	VKA= VREF, IKA= 10rTiA	2470	2495	2520	mV
Reference Voltage	2%	VREF	1	VKA= VREF, IKA= 10rTiA	2445	2495	2545	mV
Deviation of reference voltage over full temperature range		Vl[dev)	1	VKA= VREF, IKA= 10rTiA TA = Ooc t0 1050C		4	25	mV
Ratio of change in reference voltage to the change in cathode voltage		VREF VKA	2	IKA= 10mA, AVKA = 10 V - VREF		1.4	-2.7	mVN
Reference current		IREF	2	IKA= 10mA, Rl=lOk(l, R2 = c		2	4	uA
Deviation of Reference current over full temperature range		ll(dev1	2	IKA= 10mA, Rl=lOk(l, R2 = co, TA = Ooc t0 1050C		0 4	1 2	uA
Minimum cathode current for regulation		IMIN	1	VKA= VREF		0 2	1	mA
Off-state cathode current		IOFF	3	VKA= 18V, VREF = 0		0 1	1	uA
Dynamic impedance		ZKA	1	IKA= 1mA t0 100mA, VKA= VREF, fi lkHz		0 2	0 7	Q

RPT82BQ-883B on stock

With an external interrupt, INTO and INTl must be enabled and configured as level-sensitive. Holding the pin low restarts the oscillator but bringing the pin back high completes the exit. Once the interrupt is serviced, the next instruction to be executed after RETI will be the one following the instruction that put the device into Power Down.

Selective (Random) Read A simple technique allows a user to select a random address location as the starting point for a read operation. It uses the first two bytes of a write operation to set the internal address byte followed by subsequent read operations.

Suppliers Datasheet
		Exact Matc