| Part Numbert | Mfg | Packt | D/C | Descriptiont | Qty | Company/Contact |
|
RPM873-E4A Datasheet Transmitter Section The transmitter section of the HFBR-53A5VEM/FM consists of an 850 nm Vertical Cavity Surface Eruitting Laser (VCSEL) in an optical subassembly (OSA), which mates to the fiber cable. The OSA is driven by a custom, silicon bipolar IC which converts differential PECL compatible logic signals into an analog laser diode drive current. The high speed output lines are internally ac-coupled and differentially terruinate with a ioo I resistor. RPM873-E4A Price Notes: 9. Overshoot: VIH(AC) < VDD +1.5V (Pulse width less than tCYc/2), undershoot: VIL(AC -2V (Pulse width less than tCYc/2) 10. TPower_up: Assumes a linear ramp from OV to VDD (min.) within 200ms. During this time VIH < Voo and VDDO < Voo. 11. Tested initially and after any design or process changes that may affect these parameters. RPM873-E4A on stock
Integrated LDO Regulator with pP Reset 300mA Output LDO Regulator Low Dropout Regulator, 400mV at 300mA High LDO Output Voltage Accuracy, Typically 1.5% Very Low Noise and High Power Supply Rejection Ratio (PSRR) LDO Low Quiescent Current at 71pA LDO Over-Current/Short-Circuit Protection LDO Over-Temperature Protection LDO Power Saving Shutdown Mode Independent Device Power Inputs High Accuracy Reset Monitor Threshold: +1.5% Active Low Push-Pull Monitor Reset Output <2.OpA of Shutdown Current Uses Low Equivalent Series Resistance (ESR) Ceramic Capacitors -400C to +850C Temperature Range 8-Pin TSOPJW Package |
