RPM7236-HX，there are the best RPM7236-HX suppiers all over the world here.These are the list and detailed contact method of RPM7236-HX suppliers all over the world as follows.You can buy or get informations of RPM7236-HX through email , message or tel.

suppliers of RPM7236-HX and PDF data of RPM7236-HX

Part Numbert

Mfg

Packt

D/C

Descriptiont

Qty

Company/Contact

RPM7236-HX Datasheet

Characteristics	Symbol	Test Condition	Min	Typ	Max	Unit
Output voltage	VOUT	Please refer to the Output Voltage Accuracy table.
Line regulation	Reg- line	VOUT+1 V < VIKI < 15 V, IOUT = 1 mA		3	15	mV
Load regulation	Reg'load	1 mA < IOUT < 150 mA		25	75	mV
Quiescent current	IB1	IOUT=0mA		170
Quiescent current	IB2	IOUT= 50 mA		550	850	uA
Stand-by current	JB (OFF)	VCT= OV			O1	VA
Output noise voltage	VNO	IOUT = 10 mA, 10 Hz < f< 100 kHz, Ta = 250C		30		FNrms
Dropout voltage	VIN-VOUT	IOUT= 50 mA		130	200	mV
Temperature coefficient	Tcvo	-400C ' Topr < 85aC		100		ppm/oC
Input voltage	VIN		VOUT + 0.2V		15	V
Ripple rejection	R.R	IOUT = 10 mA, f= 1 kHz, VRipple = 500 mVp_p, Ta = 25aC		70		dB
Control voltage (ON)	VCT (ON)		1.5		VIN	V
Control voltage (OFF)	VCT (OFF)				0.4	V
Control current (ON)	ICT (ON)	VCT (ON) = 1.5 V		3	10	UA
Control current (OFF)	lCT(OFF)	VCT (OFF) = 0 V		O	O1	VA

RPM7236-HX on stock

Note: 1. P = Power supply. I = Input. 0 = Output. 1/0 = Bidirectional. Gnd = Ground. lpu = Input wl internal pull-up. lpd = Input wl internal pull-down. lpd/0 = Input wl internal pull-down during reset, output pin otherwise lpu/0 = Input wl internal pull-up during reset, output pin otherwise. NC = No connect. 2. PU = Strap pin pull-up. PD = Strap pin pull-down.

.009 radius typ. NOTES: 1) The package bottom thermal vias, top lid surface and 4 metallized corner castellations (when present) are all at Vss potential. 2) Alldimensions in inches. 3) Plin #1 identifier may ba an elongated pad or small, square gray marker.

Suppliers Datasheet
		Exact Matc