STROBE (pin H): A string of five sequential, active-low, STROBE pulses are output (after BUSY goes low) indicating the end of a conversion and the availability of new data.The 5 STROBE pulses occur only once per conversion, or 2.5 times each second. STROBE can be used to latch the BCD data (on pins I - L) into external latches. Either edge can be used since STROBE(~ 5Usec wide) is active only in the center of the corresponding DIGIT DRIVE and BCD DATA outputs.
RPER71E225K3 Price| | | | | L88MS05T ' VIN = 8V iV (exc apt IST, t -..- - - l |
| | | | | VST={ | | |
| | | | | | | |
| | | | | | | |
| | | | | | | |
| | | | | | | |
| | | | | | | |
| | | | | | |
RPER71E225K3 on stock| Parameter | Symbol | Ratings | Unit |
| Supply Voltage | Vcc | 6.0 | V |
| Operating Temperature | Fopr | -10+60 | |
| Storage Temperature | Tstg | -20+75 | |
| Soldering Temperature | Tsol | 260 (Max 5 sec) | |
| | | |
| l ICp=lOOmA | | | | l lOODfS |
| | | | | | | | | |
| | | | | | | | | |
| IC= | 30m} | | | | j | | |
| | | | | | | |
| | | | | | j | |
| | | | | | 3k | | |
| | | | | | q | | | |
| | | | | | | | | |
| | | | | | | | | |
| IC-LJ lL Single pulse | | | | | | |
| | | | | | | | |
