QL8X12B-XPL44，there are the best QL8X12B-XPL44 suppiers all over the world here.These are the list and detailed contact method of QL8X12B-XPL44 suppliers all over the world as follows.You can buy or get informations of QL8X12B-XPL44 through email , message or tel.

suppliers of QL8X12B-XPL44 and PDF data of QL8X12B-XPL44

Part Numbert	Mfg	Packt	D/C	Descriptiont	Qty	Company/Contact
QL8X12B-XPL44	QUICKLOGIC	PLCC44		our own stock	120	HK CHISHING ELECTRONICS COM Contact:Maggielee Tel:86-755-61303995 Fax:86-755-61306028 Email: maggielee@zcicgs.com.cn
QL8X12B-XPL44	QUICKLOGIC	our own st			PLCC44	HK CHISHING ELECTRONICS CO., Contact:maggielee Tel:86-755-61303995 Fax:86-755-61306028 Email: maggielee@zcicgs.com.cn

QL8X12B-XPL44 Datasheet

Package is non-polarized. Parts may be on reel in orientation illustrated, 1800 rotated, or mixed (both ways). Device mounted on FR-4 PCB, 1 inch x 0.85 inch x 0.062 inch; pad layout as shown on Diodes Inc. suggested pad layout document AP02001, which can be found on our website at http://www.diodes.com/datasheets/ap02001.pdf. No purposefully added Lead.
QL8X12B-XPL44 Price

Data sheet status
Objective specification	This data sheet contains target or goal specifications for product development.
Preliminary specification	This data sheet contains preliminary data; supplementary data may be published later.
Product specification	This data sheet contains final product specifications.
Limiting values
Limiting values given are in accordance with the Absolute Maximum Rating System (IEC 134). Stress above one or more of the limiting values may cause permanent damage to the device. These are stress ratings only and operation of the device at these or at any other conditions above those given in the Characteristics sections of the specification is not implied. Exposure to limiting values for extended periods may affect device reliability.
Application information
Where application information is given, it is advisory and does not form part of the specification.

QL8X12B-XPL44 on stock



	V	j	7	j	j	j

^					I	j

Notes: 1. Only a single l% resistor is required in either the r c: : ) or R2 locarion. Do not use rF._) and R2 simultaneously Place the resistor as close to the ISR as possible. 2. Never connect capacitors from Vcjadjust to either GND, V, or the Sense pins. Any capacitance added to the Vadjust pin will affect the stability of the ISR. 3. If the sense pins are not being used, the resistors C-_i and R2 can be connected to V and GND respectively Where 4. An increase in the output vokage must be accompanied by a corresponding reducuon in the maximum output current. The revised maximum output current must be reduced to the equivalent of 12Watts.

Suppliers Datasheet
		Exact Matc