| Part Numbert | Mfg | Packt | D/C | Descriptiont | Qty | Company/Contact | |
| PT2318B-S | PTC | 02+ | SMD |
|
 
|
||
| PT2318B-S | PTC | 09+ | 11 |
|
|||
| PT2318B-S | PTC | SMD | 02+ | 11 |
|
||
| PT2318B-S | PTC | SMD | 02+ | 11 |
|
||
| PT2318B-S | PTC | SMD | 09+ | new in stock | 1000 |
|
|
| PT2318B-S | PTC | 11 | SMD |
|
|||
| PT2318B-S | PTC | SMD | 02+ |
|
|||
| PT2318B-S | PTC | SMD | 02+ | 11 |
|
||
| PT2318B-S | PTC | 02+ | NEW AND ORIGINAL STO | 11 |
|
||
| PT2318B-S | PTC | 02+ | NEWANDORIGINALSTOCK! | 11 |
|
||
| PT2318B-S | PTC | SMD | 02+ | 11 |
|
|
PT2318B-S Datasheet herein do not have specifications that can handle iability, such as life-support systems, aircraft's can be reasonably expected to result in serious SANYO representative nearest you before using in such applications. PT2318B-S on stock ldle Mode In the idle mode (see Table 2), the CPU puts itself to sleep while all of the on-chip peripherals stay active. The instruction to invoke the idle mode is the last instruction executed in the normal operating mode before the idle mode is activated. The CPU contents, the on-chip RAM, and all of the special function registers remain intact during this mode. The idle mode can be terminated either by any enabled interrupt (at which time the process is picked up at the interrupt service routine and continued), or by a hardware reset which starts the processor in the same manner as a power-on reset ( z H 3 l y d ) a s ! o N l u a n n 0 ( z F f S / A u ) a s ! o N a 6 P l I o A Amplifying Signals from High Impedance Transducers The low voltage and current noise offe red by the LT1169 makes it useful in a wide range of applications, especially where high impedance, capacitive transducers are used such as hydrophones, precision accelerometers, and photodiodes. The total output noise in such a system is the gain timesthe RMSsum ofthe op amp's input referred voltage noise,the thermal noise ofthetransducer, and the op amp's input bias current noise times the transducer impedance. Figure 2 shows total input voltage noise versus source resistance. In a low source resistance (< 5k) application the op amp voltage noise will dominate |
