PBSS4350D-43，there are the best PBSS4350D-43 suppiers all over the world here.These are the list and detailed contact method of PBSS4350D-43 suppliers all over the world as follows.You can buy or get informations of PBSS4350D-43 through email , message or tel.

suppliers of PBSS4350D-43 and PDF data of PBSS4350D-43

Part Numbert

Mfg

Packt

D/C

Descriptiont

Qty

Company/Contact

PBSS4350D-43 Datasheet

The MAX9713/MAX9714 0ffer two modulation schemes: a fixed-frequency mode (FFM), and a spread-spectrum mode (SSM) that reduces EMI-radiated emissions due to the modulation frequency. The device utilizes a fully differential architecture, a full bridged output, and com- prehensive click-and-pop suppression.
PBSS4350D-43 Price

			MIN.	TYP.	MAX.
LL	ICBO	VCB=-600 V, IF:=O			-10	A
-yL	IEBO -	VEB=-7.0 V, I(:=O			-10	uA
	hFFl	Vcr. = - 5.0 V, Ic = - 0.1 A	30	58	120
	hFE2	VCF.= -5.0 V, Ic:= -0.5 A	5	19
L	Vcs¨	Ic=-0.3 A, IB=-0.06 A		- 0.28	- 0.5	V
-	VBr:(sat,	Ic=-0.3 A, IH=-0.06 A		- 0.85	-1.2	V
jU	C	VCB=-10 V, IF.=O, f-l.0 MHz		42	50	pF
	fT	VCFl=-10 V, If:.=0.1 A	10	28		MHz
- 7 7	t(n	Ic=-O.5 A, RL=500 Q		O1	0.5	S
	t stg	IHl = -IB2 = -0.1 A		3.5	5O	ZS
	tf	Vcc:= -250 V		0.08	0.5	us

PBSS4350D-43 on stock

The Read operation of the SST27SF256/512/010/020 is controlled by CE# and OE#. Both CE# and OE# have to be low for the system to obtain data from the outputs. Once the address is stable, the address access time is equal to the delay from CE# to output (TCE). Data is available at the output after a delay of TOE from the falling edge of OE#, assuming that CE# pin has been low and the addresses have been stable for at least TCE - TOE. When the CE# pin is high, the chip is deselected and a typical standby current of 10 pA is consumed. OE# is the output control and is used to gate data from the output pins. The data bus is in high impedance state when either CE# or OE# is high.

SYMBOL	PARAMETER	CONDITIONS	MIN	MAX	UNIT
VCESM	collector-emitter voltage	VBE =0		65	V
VCEO	collector-emitter voltage	open base		33	V
VEBO	emitter-base voltage	open collector		4	V
lc	collector current (DC)			12.5	A
IC(AV)	average collector current			12.5	A
ICM	peak collector current	f>l MHz		20	A
Ptot	total power dissipation (DC)	Tmb= 25 IC		132	W
Prf	RF power dissipation	f> 1 MHz; Tmb = 25 IC		165	W
Tstg	storage temperature		-65	+150	IC
Tj	operating junction temperature			200	][C

Suppliers Datasheet
		Exact Matc