PBQG09M，there are the best PBQG09M suppiers all over the world here.These are the list and detailed contact method of PBQG09M suppliers all over the world as follows.You can buy or get informations of PBQG09M through email , message or tel.

suppliers of PBQG09M and PDF data of PBQG09M

Part Numbert	Mfg	Packt	D/C	Descriptiont	Qty	Company/Contact
PBQG09M	XGI		0417CD		5	laige technology Contact:helen Tel:86-10-51987761 Fax: Email: laige-9@ic-key.com
PBQG09M	XGI	BGA3131	0417CD		5	GlitterElectronicscompany Contact:Ms.xujane Tel:86-755-83746600/83998955 Fax:86-755-83998977/83959478 Email: sales@glitter-ic.com

PBQG09M Datasheet

Collector-Base Cutoff Current (VCB = 50 V, IE = 0)	ICBO		100	nAdc
Collector-Emitter Cutoff Current (VCE = 50 V, lB = 0)	ICEO		500	nAdc
Emitter-Base Cutoff Current MUN2211T1 (VEB = 6.0 V, lc = 0) MUN2212T1 MUN2213T1 MUN2214T1 MUN2215T1 MUN2216T1 MUN2230T1 MUN2231T1 MUN2232T1 MUN2233T1 MUN2234T1 MUN2236T1 MUN2237T1 MUN2240T1 MUN2241T1	IEBO		0.5 0.2 0.1 0.2 0.9 1.9 4.3 2.3 1.5 0.18 0.13 0.05 0.13 0.2 0.1	mAdc
Collector-Base Breakdown Voltage (lc = 10 IE = 0)	V(BR)CBO	50		Vdc
Collector-Emitter Breakdown Voltage (Note 4) (lc = 2.0 rTiA, IB = 0)	V(BR)CEO	50		Vdc

PBQG09M Price

The frequency of the noise source is obtained in the PSG by first counting down the input clock by 16, then by further counting down the result by the programmed 5-bit Noise Period value. This 5-bit valye consists of the lower 5 bits (B4--BO) of register R6, as illustrated in the tollowing:
PBQG09M on stock

Resistor Selection f Setting the Output Voltage) The accuracy of VOUT depends on the accuracy of the voltage biasing Rl in Figure l. Use a separate refer- ence voltage if greater accuracy than provided by VIN is desired (Figure 4). Keep the feedback node as small as possible, with resistors mounted close to the FB pin.

The MAX921-MAX924's unique design achieves an output source current of more than 40mA and a sink current of over 5mA, while keeping quiescent currents in the microampere range. The output can source 100mA (at V+ = 5V) for short pulses, as long as the package's maximum power dissipation is not exceeded. The output stage does not generate crowbar switching currents during transitions, which minimizes feedback through the supplies and helps ensure stability without bypassing.

Suppliers Datasheet
		Exact Matc