N-5MG，there are the best N-5MG suppiers all over the world here.These are the list and detailed contact method of N-5MG suppliers all over the world as follows.You can buy or get informations of N-5MG through email , message or tel.

suppliers of N-5MG and PDF data of N-5MG

Part Numbert

Mfg

Packt

D/C

Descriptiont

Qty

Company/Contact

N-5MG Datasheet

The Transmitter Buffer Register and Receiver Buffer Regis- ter are data registers holding from 5-8 data bits. If less than eight data bits are transmitted, data is right justified to the LSB. Bit o of a data word is always the first serial data bit received and transmitted. The 82C50A data registers are double buffered so that read and write operations can be performed at the same time the UART is performing the par- allel to serial and serial to parallel conversion. This provides the microprocessor with increased flexibility in its read and write timing.
N-5MG Price

PAHAMETER	SYMBOL	MAXIMUM	UNITS
Input Voltage	VIN	40	Volts
Collector Supply Voltage	Vc	40	Volts
Source/Sink Current (per output)	10	200	mA
Thermal Resistance Junction to Ambient	OJA	125	oC/Watt
Operating Junction Temperature Range LAS 3840 LAS 384DP	TJ	- 55 to +125 O t0 70	c
Storage Temperature Range LAS3840 LAS 3840P	TSTG	- 55 to +125 - 25 to +125	c
Lead Temperature (Soldering, 10 Seconds)		260	c

N-5MG on stock

Pin	Symbol	Name/Function
1 2 3 6 7 8	INA1 INA2 INA3 INB1 INB2 INB3	TTL-compatible logic input pins for switching channels A and B, respectively (Figure l). A channel switch is normally closed if all of its inputs are logic HIGH. A logic LOW on any input pin will open the switch.
4	NC	No connection. This pin should not be used as a tie point for external circuitry.
5	V+	Connection for most positive external power supply.
9 16	SWBl+ SWAl+	One side of the switch output (designated Side l) for channels B and A, respectively.
10 13	COMMON	Ground or circuit common (not necessarily physical or system ground). All of these pins should be externally connected to one common point.
11 14	SWB2 * SWA2 *	One side of the switch output (designated Side 2) for channels B and A, respectively.
12	V-	Connection for most negative external power supply.

Property	Test Method	Unit	Value
Chemical Type			Silver filled epoxy
Appearance	Visual		Silver paste
Density	ASTM-D-792	g/cm	3.2
Brookfield Viscosity	ASTM-D-2393 5 rpm # TC	Pa.s cP	75 - 125 75,000 - 125,000

Suppliers Datasheet
		Exact Matc