| Symbol | Fermi¨nal | Function |
| Vml, Vm2 | Motor Supply Voltage | Power supply for motor drive. |
| OutlA, OutlB, Out2A, Out2B | Output terminals | Motor drive output terminals. |
| Rsl, Rs2 | Current sensor | Output current sensing resistor (Rs) connection terminals. |
| Vcc | Power supply | Control circuit power supply. |
| PhlA, PhlB, Ph2A, Ph2B | Phase input | Output current direction switch terminals. |
| 10(1), 11(1), 10(2), 11(2) | Output current change | Output current change (100%, 70%, 33%, 0%) terminals. |
| Stby | Standby input | Standby input (L: Standby, H or open: motor function) terminal. |
| S1S2 | Sense inputs | Input voltage terminal of comparators. |
| Vref | Vref input | Reference voltage due to setting output current. |
| Regout | Output of voltage stabilizer | Output of voltage stabilizer (3.5V). |
| Fref | A capacitor for oscillator | A capacitor due to PWM carrier frequency. |
| P.GND | Power GND | The GND terminal of bottom side flywheel diodes. |
| | |
9. This equivalent RLC model approximates resonator performance near the reso- nant frequency and is provided for reference only. The capacitance Co is the static (nonmotional) capacitance between pinl and pin 2 measured at low fre- quency (10 MHz) with a capacitance meter. The measurement includes case parasitic capacitance with a floating case. For usual grounded case applica- tions (with ground connected to either pin l or pin 2 and to the case), add approximately 0.25 pF to Co.
MXO45HST-3I-47.9232MH on stock| | | | | | | | | | | | |
| | | | | | | | | | | | |
| | | | | | | | | | | | |
| | | | | | | | | | | | |
| | | | | | | | - | | | | |
| | | | | | | | | | | | |
| | | | j | | | | | | | | |
| | j | | | | | u¨l9iO-LIluuIVIn | Mnrlp | | | | |
| | | | | Mode=1 | j | |
| | | | | vcc = 5.0 V, VEE = -5.0 V | | |
| | | | | VlI | =0 | | |
| | | | | | | | | | | | |
| | | | | | | | | | | |
| | Symbol | Min | Typ | Max | Unit |
| Thermal Resistance Junction to Ambient Air | RthA | | | O31) | K/mW |
| Forward Voltage at IF = 200 mA | VF | | | 1.1 | V |
| i) Valid provided that leads at a distance of 8 mm from case are kept at ambient | emperature. |
| | | | | |
