| Part Numbert | Mfg | Packt | D/C | Descriptiont | Qty | Company/Contact | |
| MC144111DWR2G | ONS | SOP | 09+ | 5000 |
|
 |
|
| MC144111DWR2G | ONS | SOP | 07+ | 2000 |
|
|
|
| MC144111DWR2G | MOT | 08+ | 特价热卖，质量保证，原装现货 | SOP |
|
||
| MC144111DWR2G | ONS | SOP16 | 09+ | 原装特价热卖 | 2500 |
|
|
| MC144111DWR2G | ONS | SOP16 | 1000 |
|
|
MC144111DWR2G Datasheet Card Detection Each CD (output) pin should be read by the host system to determine if the memory card is properly seated in the socket. CDi and CD2 are internally tied to the ground. If both bits are not detected, the system should indicate that the card must be re-inserted. MC144111DWR2G Price
MC144111DWR2G on stock (3) Start condition (start bit recognition) Before executing the various commands, a start condi- tion (start bit) must be input. This is recognized when SCL is HIGH and SDA falls from HIGH to LOW. If a start condition is not input, no commands will be received. (4) Stop condition (stop bit recognition) To terminate the various commands, a stop condition (stop bit) must be input. This is recognized when SCL is HIGH and SDA rises from LOW to HIGH. (5) Precautions concerning the write command With the write command, internal writing is initiated by inputting the stop bit after the data has been input. (6) Device addressing (specifying the slave address) The master address should be output first, followed by the start condition, and then the slave address. The first four bits of the slave address are used to recog- nize the device type. The device code for this lC is
Data is input to and output from the LC72151V using the Sanyo CCB (Computer Control Bus) format, which is the serial bus format used by SANYO audio ICs. This IC adopts a CCB format with an 8-bit address. |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
