| Part Numbert | Mfg | Packt | D/C | Descriptiont | Qty | Company/Contact | |
| AJ80A-300L-150F16 | 06+ | 200 |
|
||||
| AJ80A-300L-150F16 | ASTEC | 24 |
|
||||
| AJ80A-300L-150F16 | ASTEC | 16 |
|
||||
| AJ80A-300L-150F16 | 100 | ASTEC |
|
||||
| AJ80A-300L-150F16 | ASTEC | 240W | originalpartsinstock | 100 |
|
|
AJ80A-300L-150F16 Datasheet (3) The products described in this material are intended to be used for standard applications or gen- eral electronic equipment (such as office equipment, communications equipment, measuring in- struments and household appliances). Consult our sales staff in advance for information on the following applications: . Special applications (such as for airplanes, aerospace, automobiles, traffic control equipment, combustion equipment, life support systems and safety devices) in which exceptional quality and reliability are required, or if the failure or malfunction of the products may directly jeopardize life or harm the human body. . Any applications other than the standard applications intended. AJ80A-300L-150F16 Price These materials are solely intended for a customer's individual use. Therefore, without the prior written approval of Panasonic, any other use such as reproducing selling, or distributing this material to a third party, via the Internet or in any other way, is prohibited AJ80A-300L-150F16 on stock
Following an INIT, the parallel port will not be in the FIFO mode. Control Register bit-0 is used as the - STROBE, Status Register bit-7 is the inverse of the BUSY signal, and INT is derived from -ACK. The transition into FIFO mode will occur after the first - STROBE is generated and the printer responds with either an -ACK or BUSY. In FIFO mode, -STROBE is generated automatically and writing to Control Regis- ter bit-0 has no effect on -STROBE. Alternate Func- tion Register bit 0-2 are used to control the delay and width of -STROBE. Handshaking between the printer and the ST78C34 may be controlled by bit-3 0f the Alternate Function Register. Setting this bit to a "1 " will result in the use of BUSY instead of -ACK for FIFO reading and interrupt control. INT will transition low when a "1" is written to Control Register bit-0 and will transition high when a write to parallel port is per- formed. In FIFO mode, data transfer to the printer will be controlled by the printer and will occur at the printer's maximum data rate. |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
